Setting Memory Position and Linking Remote Keyless Entry (RKE) Transmitter to Memory in the 2009 Jeep Grand Cherokee

If your 2009 Jeep Grand Cherokee is equipped with driver memory seat function, the memory buttons 1 and 2 on the driver’s door panel can be used to recall driver’s seat, outside mirror, adjustable brake and accelerator pedals, and radio station settings. The Remote Keyless Entry (RKE) transmitter can also be programmed to recall the same positions when the UNLOCK is pressed.

To set memory positions and link Remote Keyless Entry (RKE) Transmitter to memory, do the following:

Note: Each time the S (Set) button and button 1 or 2 are pressed, you erase the memory settings for that button and store a new one.

2009 Jeep Grand Cherokee Driver Memory Switch

  1. Insert the ignition key, and turn the ignition switch to the ON position.
  2. Press the driver door memory button 1 to set the memory for driver 1, or button 2 if you are setting the memory for driver 2. The system will recall any stored settings. Wait until the system recall is complete before continuing.
  3. Adjust the driver’s seat, recliner, and driver’s side-view mirror to the desired positions.
  4. Adjust the brake and accelerator pedals to the desired positions.
  5. Turn the radio on and set the radio station presets. Up to 12 AM and 12 FM stations can be set.
  6. Turn the ignition switch to the LOCK position and remove the key.
  7. Press and release the S (Set) button located on the driver’s door.
  8. Within 5 seconds, press and release memory button number 1 or 2 on the driver’s door. If you intent to also use a RKE transmitter to recall memory positions, step 9 must be performed within 5 seconds.
  9. Press and release the LOCK button on one of the RKE transmitters.
  10. Insert the ignition key, and turn the ignition switch to the ON position.
  11. Select “Remote Linked to Memory” in the Electronic Vehicle Information Center (EVIC) and enter “YES”.
  12. Repeat the above steps to set the next memory position using the other numbered memory button, or to link another RKE transmitter to memory.

Related posts:

Leave a Reply

Your email address will not be published. Required fields are marked *